When unpacking the machine, remove the plastic film, water tank, drip tray, and capsule container. Adjust the cable length and store the excess in the cable guide under the machine. NOTE: to turn off the machine, press Lungo and Espresso button for 2 seconds.

Rinse the water tank before filling with potable water up to maximum level. Plug machine into mains.

Switch the machine on by pressing any of the three buttons:

Blinking lights: heating-up (25 sec)

Steady lights: ready

Rinsing: place a container under coffee outlet and press the Lungo button. Repeat three times. INFO: Machines are fully tested after being produced. Some traces of coffee powder could be found in rinsing water.

Disassemble the Rapid Cappuccino System and clean all 5 components in the upper level of your dishwasher. In case a dishwater is not available, refer to the “Hand Washing of Rapid Cappuccino System” section. INFO: Refer to section “Assembling / Disassembling of Rapid Cappuccino System” section

Lift the lever completely and insert the capsule.

Close the lever and place a cup under the coffee outlet.

Press the Espresso (40ml) or the Lungo (110ml) button. Preparation will stop automatically. To stop the coffee flow or top up your coffee, press again.

Lift and close the lever to eject the capsule into the used capsule container. NOTE: during heat up, you can press any coffee buttons. The coffee will then flow automatically when the machine is ready.

Remove the milk container by pressing the button on the side of the milk jug. Unplug the aspiration tube.

Position the milk spout vertically to disassemble and to reassemble. Press the button on the side of milk jug to pull out the milk spout

Press the button on the side of milk jug and pull to unlock the rapid system connector.

Fill the milk container up to one of the two levels indicators:

Cappuccino Latte Macchiato

Close the milk container and connect the Rapid Cappuccino System to the machine. Machine heats up for approximately 15 seconds (blinking lights). INFO: The milk system has not been designed to work with vegetale milk. For a perfect milk froth, use skimmed or semi-skimmed cow milk at refrigerator temperature (about 4° C). NOTE: the Rapid Cappuccino System does not work with water.

Lift the lever completely and insert the capsule. Close the lever.

Place a Cappuccino cup or a Latte Macchiato glass under the coffee outlet and adjust milk spout position by lifting it up to the right level.

Press the milk button. NOTE: all milk will be used for the drink.

At the end of the preparation, the clean alert illuminates orange to indicate it is necessary to clean the Rapid Cappuccino System. INFO: The preparation starts after a few seconds (first milk and then coffee) and will stop automatically.

Lift and close the lever to eject the capsule into the used capsule container.

After a period of non use of maximum 30 minutes after your milk recipe preparation, disassemble the Rapid Cappuccino System, and clean all components in the upper side of your dishwasher. In case a dishwasher is not available, refer to section "Hand washing of Rapid Cappuccino System." Refer to section “Assembling / Disassembling of Rapid Cappuccino System”. The Rapid Cappuccino System is not intended to be stored in the fridge.

Touch and hold Espresso or Lungo button for at least 3 sec to enter the programming mode. Brewing starts and button blinks fast.

Release button when desired volume is reached. Coffee volume is now stored for the next coffee preparations. Button blinks 3 times to confirm the new coffee volume. NOTE: please refer to factory settings section for min / max programmable quantities.

Lift and close the lever to eject the capsule into the used capsule container. Remove drip tray, capsule container. Empty and rinse. Remove water tank. Empty, rinse it before filling with potable water.

Lift and close the lever to eject the capsule into the used capsule container. Place a container under coffee outlet and press the Lungo button to rinse. Clean the coffee outlet with a clean damp cloth.Place a container under coffee outlet and press the Lungo button to rinse.

Clean the coffee outlet and machine surface with a clean damp cloth. INFO: Do not use any strong cleaning agent or solvent cleaner. Use a clean damp cloth and mild cleaning agent to clean the surface of the machine. Do not put any machine components in dishwasher, except the Rapid Cappuccino System components.

Disassemble the Rapid Cappuccino System. Refer to section "Assembling/Disassembling of Rapid Cappuccino System". Rinse away carefully any milk residue with hot potable water (40°C/104°F)

Soak all components in with hot potable water (40°C/104°F) together with mild/soft detergent for at least 30 minutes and rinse thoroughly with hot potable water (40°C/104°F). Do not use odor mild/soft detergents

Clean the interior of the milk tank with mild/soft detergent and rinse with hot potable water (40°C/104°F). Do not use abrasive material that might damage the surface of the equipment.
* Ensure air inlet is clean.

Dry all parts with a fresh and clean towel, cloth or paper and reassemble. INFO: When a dishwasher is not available, the Rapid Cappuccino System components can be washed by hand. The procedure must be performed after each use.

Switch the machine ON. NOTE: Remove milk jug.

Press the milk button for 3 seconds to enter Menu mode: descaling and clean alert start blinking.

Press the milk button. The milk button blinks to indicate reset mode. Press it to confirm. All buttons blink 3 times: all volumes are reset. The menu exits automatically and machine returns to ready mode. NOTE: the Menu mode exits automatically after 30 sec if no actions are performed or can be exited manually by pressing milk button 3 seconds.

CAUTION: if coffee volumes higher than 150 ml are programmed: let the machine cool down for 5 minutes before making the next coffee. Risk of overheating!

NOTE: the milk froth volume depends on the kind of milk that is used and its temperature.

NOTE: we recommend you to keep factory settings for Espresso and Lungo to ensure the best in cup results for each of our coffee varieties. Default values: Lungo (110 ml), Espresso (40 ml), Coffee 40 ml / Milk drink: from 50 to 125 ml. Automatic Power Off 9 minutes

Coffee volume can be progammed from 25ml to 150 ml

Descale the machine when descaling alert shines orange in ready mode. NOTE: descaling time is approximately 20 minutes. To ensure the proper functioning of your machine over its lifetime and that your coffee experience is as perfect as the first day, follow the below process.

Lift and close the lever to eject any capsules in the used capsule container.

Empty the drip tray and the used capsules container. Fill the water tank with 100ml of Nespresso descaling agent and 500ml water.

Take the descaling pipe situated at the back of the machine and plug the descaling pipe into steam connector of machine.

The machine enters the descaling mode. The descaling alert blinks orange during the entire descaling process. The Espresso button illluminates white

Place a container with a minimum 1 litre capacity under both the coffee outlet and under the descaling pipe nozzle.

Press the Espresso button. Descaling product flows alternately through the coffee outlet, descaling pipe and drip tray. When the descaling cycle is finished (water tank runs empty), the Espresso button shines.

Empty the used capsules container, drip tray recipient and container, rinse out and fill the water tank with fresh potable water up to level MAX.

Press the Espresso button again. The rinsing cycle continues through the coffee outlet, descaling pipe and drip tray until the water tank turns empty.

Once the rinsing process is finished, the machine switches off. Remove and store descaling pipe. Empty drip tray and used capsules container. Fill water tank with potable water.

Clean the machine using a damp cloth. You have now finished descaling the machine

Take water hardness sticker placed on the first page of the UM and place it under water for 1 second. NOTE: the Menu mode exits automatically after 30 sec. if no actions are performed. It can be exit manually by pressing the milk button for 3 seconds.

The number of red squares indicates the water hardness level.

Switch the machine ON. NOTE: remove milk jug.

Press the milk button for 3 seconds to enter Menu mode: descaling and clean alerts start blinking.

Press the Espresso button.

Now, within 15 sec, you can set the desired value by pressing the corresponding button. They blink 3 times rapidly to confirm new value. The menu exits automatically and machine returns to ready mode.

Switch on machine. NOTE: remove milk jug.

Remove the water tank. Lift and close the lever to eject any remaining capsule. Place a container under the coffee outlet.

Press the milk buttons for 3 seconds to enter Menu mode: the descaling and clean alerts start blinking. NOTE: the Menu mode exits automatically after 30 sec. If no actions are performed. It can be exit manually by pressing the milk button for 3 seconds.

Press milk and Lungo buttons simultaneously.

The milk button blinks for confirmation. Once pressed, the emptying starts. The coffee buttons blink alternately: emptying mode in progress. When the process is finished, the machine switches off automatically. NOTE: appliance will be blocked for approximately 10 minutes after emptying.

Switch on machine. NOTE: remove milk jug. INFO: The appliance switches off after 9 minutes after last use (factory settings).

Press the milk button for 3 seconds to enter Menu mode: the descaling and clean alerts start blinking. NOTE: the Menu mode exits automatically after 30 sec. If no actions are performed. It can be exit manually by pressing the milk button for 3 seconds.

Press Lungo button.

Now, within 15 sec, you can set the desired value by pressing the corresponding button. They blinks 3 times rapidly to confirm new value. The menu exits automatically and machine returns to ready mode. Automatic Power Off: Milk (9 minutes), Lungo (30 minutes), Espresso (8 hours).